Verify your installation

This section describes the steps to verify the installation of a 40G Fail-Open module.

Verify the following to make sure your setup is working as designed.

Task

  1. If the connection with the Sensor is in inline mode. The installation in inline mode is successful if:


    • The IN LINE LED is solid green.
    • The BYP/TAP/DISC LED is off.
    • The HB LED is flashing green.
  2. If the connection with the Sensor is in bypass mode. The installation in inline mode is successful if:


    • The IN LINE LED is off.
    • The BYP/TAP/DISC LED is solid amber.
    • The HB LED is flashing green.