Advanced Configuration page for Windows client

Use this page for configuring access protection and other settings for the McAfee DLP Endpoint for Windows client.

Option definitions
Category Option Definition
Endpoint Settings Delay the start of DLP client Time interval between logging on and client up. In rare cases, the endpoint software needs more time to load. Reset this default as recommended by Support. Changing this setting requires an endpoint restart. Default: Run immediately
Run DLP client in Safe Mode When enabled, activates endpoint protection when the computer starts in Safe Mode. Default: Disabled
Maximum DLP client memory used (MB) Limits the McAfee DLP Endpoint client memory. If a process pushes the client software over the set limit, it closes and restarts. Range: 150–500
Access Protection Settings DLP access protection When enabled, activates the DLP data access protection features. Default: Enabled in both Device Control and full McAfee DLP Endpoint.
Show challenge response on upgrade When enabled, activates the challenge/response pop-up window on upgrade. Default: Enabled
Show challenge response on uninstall When enabled, activates the challenge/response pop-up window on uninstall. Default: Enabled
Run DLP client watch dog When enabled, monitors the endpoint processes and restarts them if closed. Changing this setting requires a client computer restart. Default: Enabled
Run DLP client service watch dog When enabled, monitors the watch dog and restarts it if it closes. Changing this setting requires a client computer restart. Default: Enabled
Agent Bypass Stop agent bypass immediately when a new client configuration is loaded by McAfee DLP Endpoint client. When selected, stops the agent bypass when the client configuration is updated. Default: Deselected (bypass continues to timeout)